[Tony Curnick]

Here you go Paul, the fishish rod is 18 mm OD at the base where th coil connects,24 mm at the top of the shaft with a 20mm OD tube glued in at that end to accommodate the arm cuff and must measure around 22mm at the point where the handle fits to the shaft as I used a mountain bike bar end..which is designed to clamp on 22mm tubing!

[Tony Curnick]

The reinforcing sleeve was cut from a 24 mm OD left over as it's ID was a snug fit to the base off the shaft....and Bob's ur Uncle!

[Paul van Heerden]

Nicely done Tony

[Tony Curnick]

Tony, I see some changes to your shopfront signwriting coming...Something like Tony's Custom Coil and Shaft perhaps...

As you already know Jaco I just love making things, I would love to just make custom parts (one offs) for the rest of my life but I still gotta pay the bills and school fees...Some of what I do is design and problem solving but the bike shop keeps the wolves at bay!!!!

[JacoS]

Hmmm, have a commission for you. Design and manufacture a device to strap my MD onto my back while on the dirtbike to get to all those hard to reach spots in the Heidelberg hills, and while your'e at it something to keep me upright on the bike while in said hills!

[Paul van Heerden]

Hmmm, have a commission for you. Design and manufacture a device to strap my MD onto my back while on the dirtbike to get to all those hard to reach spots in the Heidelberg hills, and while your'e at it something to keep me upright on the bike while in said hills!

I would also like something like that for me to get around on my bike. It would be nice not to drive the car all the time

[Tony Curnick]

Already planning

[Tom White]

I have seen it at the Monument well done Tony looks professional.